Join Date: Jun 2012
Posts: 3,071
# 1 Bug: multi-select and y values
10-23-2012, 02:44 PM
OK, well I knew this was screwy before, but now I've tested it enough to know the pattern.

If I have objects set to customized y values like -4.5 and I copy the group, then cntl v to paste it on the map, the y value of the multi-select will show the correct value of -4.5, but when previewing the map, they have reverted to the 0 value up in the air.

I have to manually change the y value of a group to something else, before then re-entering the correct value of -4.5. Then they load properly on a map.

Basically I have to undo and re-enter the y value of a multiple selection.

To test, put a set of long candlesticks beneath the ground, but sticking out of the ground, set to absolute zero. -4.5 y may work depending on the map.

Copy a group by selecting the first and holding down cntl + alt while adding the other candlesticks. With the group selected, hit cntl c, then cntl v. Notice the y value of the group.

Load the map to see that they are now up in the air. Go back into the Foundry and change the y value of the group to 6, hit enter, now change it back to -4.5.

Now load the map to see that the y value of the group is now correct.

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

All times are GMT -7. The time now is 08:38 PM.